The Titanium scale is one of the basic knowledge of titanium. The Titanium scale usually refers to the length of titanium. Titanium length mainly includes length, width, height, diameter, radius, inner diameter, outer diameter and wall thickness and so on. Titanium length units are meters (m), centimeters (cm), millimeters (mm) and so on. They have to learn about Titanium Tubing. Titanium tubing includes rods, plates, Titanium Tubing, titanium wires, etc. They are rolled from titanium and titanium alloys.
1. Scale measurement of titanium material
It is a useful way of saving information. Scale is the length or length times width is not less than a certain scale, or the length of the titanium plate. length times width from how numerous to how numerous scales within the delivery scale. Production units can produce and supply according to this scale demand.
2. Variable ruler
Refers to the general length, where the product scale (length or width), in the regular scale of the specification, and does not need a fixed scale called indefinite ruler. Variable ruler length is also known as general length (ruler). According to the indefinite delivery of metal materials, as long as in the regular length of the scale of delivery. For example, the general circular titanium is not greater than 25mm, its general length rule is 4-10m, then the length of the circular titanium within this scale can be delivered.
3. Measure the size
According to the order requirements cut into a fixed scale called the ruler. When delivery is made at the fixed length, the metal materials to be delivered must have the length specified by the demander in the purchase contract. For example, if it is stated in the contract that the delivery shall be made at a fixed length of 5m, it is necessary for the delivered data to be 5m in length. If it is shorter or less than 5m, it will be deemed unqualified. But in fact, the delivery can not be all 5m tall, therefore the rule is allowed to have a positive error, not allowed to have a negative error.
4. Double the size
According to the order requirements of the fixed scale cut into integral multiples called multiple ruler. The length of the metal to be delivered shall be an integer multiple (plus saw edge) of the length (single size) specified by the buyer in the purchase contract. For example, in the order contract, the buyer needs the length of a single square meter to be 2m, so that when it is cut into double square meters, the length is 4m, and when it is cut into three square meters, it is 6m, and one or two sawing edges are added. The amount of saw blade has rules in the specification. When times the scale delivery, only allow a positive error, do not allow negative bias.
5. Narrow ruler
The width is less than the lower limit of the indefinite ruler width of the rule, but not less than the corresponding narrowest width is called narrow ruler. It is necessary to pay attention to the share of the narrow gauge and the narrowest gauge of the relevant specification rules when delivering the narrow gauge.
6. Short ruler
The length is less than the lower limit of the indefinite length of the titanium tube specification, but not less than the shortest allowable length is called short length. For example, in the regulations of titanium pipes for water and gas transportation, there are 10% (according to the number of roots) 2-4m short-scale titanium pipes per batch. 4m is the lower limit of indefinite length, and the shortest length is 2m.